Denver HVAC Help

Boiler and radiator repair in Denver

A good share of Denver’s early housing still heats with hot water, a cast-iron boiler in the basement and radiators or baseboards in the rooms. It is quiet, even and long-lived heat, and it is also a trade that fewer providers know well. The first question is whether the person on the phone works on boilers regularly.

What a boiler service call covers

A hot-water boiler heats water and circulates it through the house, and most problems fall into a few groups: pressure, circulation, ignition and air. Pressure that is too low or too high points at an expansion tank, a pressure relief valve or a slow leak. Circulation trouble, with some radiators warm and others cold, points at a failing circulator pump, a stuck zone valve or air trapped in the system. Ignition is much like a furnace: an igniter, a gas valve and a flame sensor.

Radiators that stay cold at the top are often just air, and bleeding them is a routine job. Radiators cold across the whole length may have a closed valve or a circulation fault. A provider who works on boilers will check pressure, temperature and flow, not just swap parts.

Why age matters, and what to ask

An old boiler can last for decades with care, and many Denver houses still have one that predates the current owner. The concerns at that age are leaks, corroded fittings, and combustion and venting that no longer meet current practice. A provider can tell you whether a repair is sensible or whether a replacement, a high-efficiency boiler or a switch to forced air, deserves a look. Ask for the options with the work and the permit written down.

Boiler questions, answered plainly

Why are some of my radiators cold?
Trapped air, a stuck zone valve, a closed radiator valve or a weak circulator pump are the usual causes. Bleeding the radiator is a good first step if it is cool only at the top.
What should my boiler pressure be?
Most residential boilers sit around twelve to fifteen psi when cold, but the rating plate and the manufacturer’s instructions are the authority. A reading that keeps dropping suggests a leak.
Can I add air conditioning to a house with a boiler?
Yes, with ducted equipment or ductless mini-splits. Houses without ducts usually do better with mini-splits, which avoid the cost and disruption of routing new ductwork.
Most of what keeps a Denver house warm sits below the floor. What happens in the basement decides the winter. Where in a Denver house the trouble on this page usually starts.
Basement Point 1: thermostat 1 Point 2: return and filter 2 Point 3: basement furnace 3 Point 4: coil and condensate drain 4 Point 5: basement ducts 5 Point 6: outdoor unit 6
  1. 1 Thermostat: It decides when everything starts. In April it can call for heat at dawn and cooling by afternoon.
  2. 2 Return and filter: Where the house breathes in. Dry Front Range air clogs it faster than most owners expect.
  3. 3 Furnace: In a basement closet, idle for six months, then asked for everything on the first cold night.
  4. 4 Coil and condensate drain: Ice in July if airflow drops, a frozen drain line in January if the route crosses a cold corner.
  5. 5 Basement ducts: Sheet metal through the joists and up old chases, with leaks in places nobody visits.
  6. 6 Outdoor unit: Thin air, cottonwood fluff in June and a long dry spell: less margin than the label implies.

Other services covered here

Areas covered

All areas covered