Compare Denver HVAC quotes by what each one covers
Two bids on one Denver house can land thousands apart, and the gap rarely comes from the equipment. It comes from a line that one bid spells out and the other skips. Tick what each bid specifies and the missing lines show up.
Nothing leaves your device. The checklist runs in your browser, with no form and nothing stored or sent.
Set your bids side by side
| Does the quote specify… | A | B | C |
|---|---|---|---|
Heating and cooling load worked out for this house, with the result stated Why it mattersA size copied from the old unit repeats whatever the first installer got wrong. The bid should state the load that was calculated and the capacity chosen, and the two should be close to each other. | |||
Make and model of every component Why it matters“High-efficiency system” is a sales phrase, not a spec. Furnace, coil, outdoor unit and thermostat should be listed by model, since matched parts are what the efficiency ratings and the warranty assume. | |||
Furnace setup for Denver’s elevation Why it mattersGas equipment burns differently at a mile up. The bid should say what altitude setting, orifice or kit is used and that gas pressure will be measured, because a sea-level setup can run sooty or overheat. | |||
Flue, combustion air and gas line Why it mattersIn a basement closet shared with a water heater these are the expensive surprises. A new furnace often needs a different vent than the old one, and a bid that is silent here may add a change order later. | |||
Ducts: tested, and what is done about them Why it mattersDenver ducts hang under the basement ceiling and climb through old chases, and many leak. New equipment pushing air through leaky ducts loses part of its output from the first day, and this is the line most often left out. | |||
Refrigerant lines: new, or cleaned and pressure-tested Why it mattersOld copper holds old oil and debris that a new compressor then inherits. Replacing or properly flushing it is real labor, and a bid that says nothing probably reuses the old lines as they are. | |||
Electrical: breaker, wiring and disconnect for the new equipment Why it mattersNew equipment seldom draws the same current as the old. The bid should say who checks the circuit and what happens if it needs work, settled before installation day and not during it. | |||
Condensate route, including protection from freezing Why it mattersA high-efficiency furnace drains water through a small line. If it crosses a cold basement corner or a garage it can freeze in January. A float switch and a sensible route are small items that quotes often skip. | |||
Start-up readings: charge, airflow and gas pressure, handed over Why it mattersIdentical equipment performs like two different machines depending on whether anyone measured it at the end. Written readings prove the job was finished and not only installed. | |||
Permit and inspection: who pulls it, and is it priced in Why it mattersIt may be included, billed on the side or left to you, and those are three different deals. The permit also depends on the contractor’s license, so ask for the license number. | |||
Labor warranty, and who registers the equipment Why it mattersThe manufacturer stands behind the equipment, and the installer stands behind the work that fails far more often. Many manufacturers extend their term only if the unit is registered, so ask who files it. | |||
Thermostat: included, compatible and set up Why it mattersMulti-stage furnaces and heat pumps need a control that can actually run them. A badly configured one can lean on backup heat all winter, a tiny line with large consequences for the bill. | |||
| Items specified | 0/12 | 0/12 | 0/12 |
Your result
Reading what you get
A longer list is not proof of a better deal, and a lower price is not proof of an incomplete one. What the grid shows is where two prices answer different questions. If one bid includes duct repairs and the other never mentions ducts, they do not describe the same job, and the difference will surface later instead of vanishing.
Do not simply pick the longest column. Go back to each contractor who left a line empty, ask for it in writing, and run the comparison again.
Use this page
Feel free to link to this checklist or pass it along, crediting denverhvachelp.com. Neighborhood groups, landlords and anyone helping an older neighbor are who it was written for.