The first cold night checklist
A furnace that has rested for six months is asked to work all night the first time the temperature drops. Most of what goes wrong that night could have been found on a mild afternoon in September, with a screwdriver, a filter and ten minutes.
Do these before the first cold snap
Replace the filter, and write the date on it. Set the thermostat to heat and raise it a few degrees to confirm the furnace starts and the blower runs. Listen for unusual noises and note any smell, which on the first run is often only dust burning off the heat exchanger. If the smell is sharp or does not fade, turn the system off.
Look at the condensate line on a high-efficiency furnace, and follow it to where it drains. It should slope, be free of kinks and be out of any corner that freezes. Test the carbon monoxide detectors on every level and replace them if they are past their rated life.
If you have a humidifier or a boiler
Dry Denver winters make humidifiers common. Replace the water panel, check the water line and set the humidistat for the outdoor temperature, since too much indoor moisture on a very cold day condenses on windows. If the house has a boiler, check the pressure, bleed any radiator that is cold at the top and listen for the circulator pump.
When to call someone
If the furnace does not start, starts and shuts off, smells sharply of gas or exhaust, or you cannot account for a carbon monoxide alarm, leave the system off and call a licensed provider. If you smell gas, leave the house and call the utility from outside.